Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

08.06.2025 09:44

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

a photo is worth a thousand words.

the problem then depends on "how fast does the fuse operate?".

Do you think your landlord should have a key to your room?

eight

2024–10–16 [ OO OLAOYE OYEBODE ]

but this device (an Inductor) … impedes the rapid changes in the current.

What 10 things have you stopped doing in your life?

He then describes Rainy Season and Lightning.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

This is 'the assistant's answer'

How do you perform a lap dance for your boyfriend or husband?

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

Whole Foods is opening new stores in 2025: See locations - USA Today

An AC voltage/ current source, and an ac inductive load.

[image of Common-mode choke]

First Sentence:

Bill Oram: Seriously, who is going to beat the Beavers? - OregonLive.com

This one hit behind the barn.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

Atheists, there is a god up there in heaven and he loves you so much that he sent his son to die the worst death imaginable and then to turn into a zombie all to save you from sin. Why do you reject him?

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

Upvotes:

Why are there no fossils for the 'missing link' that connects our ancestors with other species? Is this a misconception or is there another explanation?

The MOV will conduct when the voltage exceeds 50% of line voltage.

What is lightning?

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

Were the 1980s as uptight and prudish as movies and TV shows make them out to be? When I think of 80s culture, I think about a very "icky" judgmental yuppie status quo time period.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

so, what happens?

Shared Genetic Signatures Found Across Psychiatric Disorders - Neuroscience News

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

Edit 2024–10.

Barnstars:

Have you ever answered your door in lingerie?

Here is a simplified AC power diagram.

One

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

Can relationship issues cause depression?

but I think this circuit , shows a few more pieces.

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

So, the voltage could go up to 500 volts, and the fuse will not open up.

It seems Mohan does not understand the difference between a comment and an Answer.

He then describes the function of a fuse.

Because the load is inductive, the current lags the voltage.(by a bit).

What does a fuse do?

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

There are two important concepts here.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

[old diagram got deleted by accident]

(Dc diagram shown, AC is similar).

A circuit breaker is similar, but is resettable.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

There are three different concepts here that are getting confused.

2024–10–10[John johnson John Johnson ]

This is where this question deviates from being a 'generic' question, and becomes more specific.

But it can get overloaded, and no longer works.

what exactly is a ‘surge’ protector?

One is “what exactly is in a ‘surge protector’ ? ”

A fuse is a non-resetable over current circuit protector.

For this case there are devices called Metal oxide varistors (MOV).

nine

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

He then asserts :

These are simplified answers to the original question, and does not change anything I wrote above.

Can the fuse protect the electronic devices from lightning instead of a surge protector.

The bolt then partially travels down the line to your home.

This is the picture of an electronic coil of wire wound around a core of magnetic material.

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

2024–10–14 [Omar Gharbi Omar Gharbi ]

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

The third is lightning and “how it gets conducted into a home.”

It also is a device that limits the change in current flow.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

At least they know the answer if they wanted it.

The other is “what does a “fuse” do?”

I post the exact comment here.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

Now when you have a certain ac resistance, then a current flows in a loop.

This device then solves the entire problem.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

In schematic diagrams this is the symbol for a fuse:

At one ohm, the resistor has a maximum of 1 watt power.

But… the neutral is now “floating” because of the 1 ohm resistance.

This is where the MOV conducts again, and dissipated the energy.

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

These devices are installed between the “hot” and “neutral” and protective ground.